Contact No. 07020814816 / 08087778631

Address: - G 17/8, Tarapur MIDC, Boisar West,  Palghar, Maharashtra India 401506

Stanrose® AC Cleaner

“Stanrose® AC Cleaner” is a powerful solvent emulsion cleaner for the cleaning of diesel engine air coolers, scavenging air systems and compressor sides of turbochargers.

Common Name

Air Cooler Cleaner

Product Code

STAN-CLC078

Features and Benefits

Formulated to remove oil, grease and carbon deposits from air coolers and scavenging systems
Efficient and economical.
May be used for in-service cleaning.
Renders surfaces oil-repellent.
Maintains and stabilises air cooler efficiency at maximum.
Saves time, maintenance costs and avoids risks of damage when dismantling.
Leaves no residue and has no harmful effect on engine.
Product in water solution is non-flammable, non-explosive and has no flash point.
Can be used for light carbon removal from machinery parts.

Technical Properties

Form - Liquid
Appearance - Light Yellow
Density - 1.1
Flash Point - Above 610 C
Compatible - May swell rubber and synthetic rubber

Recommended Uses

This composition meets the criteria for not being harmful to the marine environment according to MARPOL Annex V and may be discharged into the sea when used to clean cargo holds and external surfaces on ships.

Method of Application

In-service cleaning :
The general principle is to inject a solution of “STANROSE® AC CLEANER” into the air trunking upstream of the charge air cooler, followed by a clean water rinse. For efficient cleaning of air coolers, it is necessary to use correctly installed dosing and injection equipment. To calculate the amount of solution required to clean an air cooler, calculate or find the crosssectional area of the cooler and use 3 litres of cleaning solution per square metre or as table below:
Engine HP to Solution mix. with 25% Air Cooler Cleaner
6,000 to 12,000 3 litre mix
12,000 to 24,000 4.5 litre mix
24,000 or more 6 litre mix
For in-service cleaning of the air cooler and air-side of turbochargers, a solution of 25% Air Cooler Cleaner in freshwater is recommended.The appropriate dose of cleaner is then put in the dosing pot and injected up-stream of the air cooler in 10 minutes. After a further 10 minutes, a similar quantity of fresh water is injected to rinse off the emulsified deposits. Rate and frequency of application depends mainly on the condition of the air coolers. However, when starting with the use of “STANROSE® AC CLEANER”, we recommend injection every 24 hours. After initial cleaning period, the cleaning effect should last for 48 hours of operational time. Although frequency of cleaning may vary, the calculated cleaning dose should remain the same. This cleaning method is only recommended if approved by engine manufacturers.

Out of Service Cleaning :

Hand Spray Cleaning
In this situation the engine must be stopped.
Open an appropriate air trunking inspection cover.
Open air cooler drain valves.
Using a pressure hand Spray, apply undiluted Air Cooler Cleaner all over the cooler coils. Allow the “STANROSE® AC CLEANER” to penetrate the deposits for a minimum of 1 hour, then use a high pressure lance or water jet to wash off the loosened deposits.
After satisfactory cleaning, and flushing through with fresh water, close air cooler drains.

Soak Method
This method may be used for machine parts with stubborn carbon deposits. Put parts to be cleaned into a bath of undiluted “STANROSE® AC CLEANER” and allow deposits to be broken down and loosened before removal, then rinse.

Stanair Cool – 2010 Injection System
The engine manufacturer should be consulted before installing injectors.
Large engines will normally require two injectors per cooler, but one injector is usually sufficient for medium and small engines.

Storage and Handling

Keep away from heat, sparks and open flame. Ensure that the working area is well ventilated.
Store at moderate temperatures in dry, well-ventilated area.

Packing Available

25 Ltr. / 210 Ltr.

Follow Us On
  • Facebook Stanrose Boisar Palghar  India
  • Instagram Stanrose Boisar Palghar Mumbai Maharashtra India
  • YouTube Stanrose Boisar Palghar Mumbai Maharashtra India
  • Twitter Stanrose Boisar Palghar Mumbai Maharashtra India
  • LinkedIn Stanrose Boisar Palghar Mumbai Maharashtra India
Get a quote: 070-20-814-816
Find Us On
  • indiamart-com-branch-office--rohini-sect
  • trade-india-boisar-stanrose-floor-coatin
  • stanrose-on-justdial-pu-flooring-epoxy-f
  • trust-seal-indiamart-stanrose-boisar-flo
Quick Links
Address

G 17/8, Tarapur MIDC, Opp. Lalit Hotel,

Boisar West Palghar 401506 Maharashtra India

Contact Details
info@stanrose.co.in / sale@stanrose.co.in
Tel: 808-777-86-31 / 702-081-48-16