Contact No. 07020814816 / 08087778631
Address: - G 17/8, Tarapur MIDC, Boisar West, Palghar, Maharashtra India 401506
Stanrose® Anti Moist Electrosolv
Stanrose® Anti Moist Electrosolv is a multi purpose cleaner that easily removes oily soils, displaces water, and leaves behind a lubricating, corrosion protective, non-greasy film, Stanrose® Anti Moist Electrosolv maintains and restores electrical and electronic equipment from the effects of moisture and corrosion. It also protects metals against corrosion.
Moist Remover Electrical Cleaner
Features and Benefits
Stanrose® Anti Moist Electrosolv has a low surface tension and high capillary action that allows it to spread rapidly over any metal surface, displacing water and moisture as it spreads. Its penetrating action seals the metal surface preventing corrosion, restoring and maintaining resistance of insulating materials.
Refer technical data sheet
Stanrose® Anti Moist Electrosolv be safely used on all metals and painted surfaces, motors, control panels, switchgear, ignition systems, relays, precision tools and instruments, machined surfaces, etc. It will not harm most plastics, rubber or paint when used as directed.
Method of Application
Liberally apply Stanrose® Anti Moist Electrosolv on all surfaces and equipment to be cleaned and protected. This can be done by aerosol spray, brush, swab of immersion methods. For scaled/ solid surfaces apply Anti-Moist thoroughly to form protective film over descaled areas. Immersion of wet parts will cause water to fall off and sink to bottom of container. There is no need to remove Anti-Moist before using equipment. However, prior to painting of parts treated with Anti- Moist rising with Stanrose® Electrical Cleaning Solvent may be desirable. For restoration of electrical equipment and metal parts after flooding, firstly, remove salt water deposits and dirt with fresh water. Then saturate all parts of the equipment with Anti-Moist preferably by immersion. Periodic measurement of the insulation resistance will indicate return of equipment to operating conditions.
Storage and Handling
Anti-Moist should be used only with adequate ventilation. Avoid prolonged breathing of vapours or skin contact. DO NOT SWALLOW. Keep away from open flame and high radiant heat. Do not puncture or throw aerosol cans on fire.
Avoid contact with eyes and skin. In case of contact rinse with plenty of water. Wear suitable protective clothing, gloves and eye/face protection.
Keep away from heat, sparks and open flame. Ensure that the working area is well ventilated.
Store at moderate temperatures in dry, well-ventilated area.