top of page
Stanrose® Electrosolv is an excellent Electric Parts cleaneing solvent. It is a perfect blend of non-chlorinated degresol with surfactants which help in degreasing and cleaning electrical equipments.
The application of this product is very easy and it can be used for all electrical equipments. It is suitable to use on painted or varnished metal surfaces too. It may have an adverse effect on rubber or plastic. It is advisable to either remove the rubber or plastic parts if possible, or experiment on small portion of such parts before use.
The Salient features of Stanrose® Electrosolv are that it provides immediate and efficient cleaning with quick drying property. It has high dissolving and penetration action so easily mixes with solvents and helps cleaning even heavy dirt. It is safe on applied electrical insulation and it is non corrosive nature makes it easier to use even on painted and varnished surfaces without causing any harm to it. It does not contain chlorinated solvents. It has excellent degreasing and emulsification power even for toughest dirt and grime. It can be used as an alternative to conventional electric cleaners. It has eco friendly components making it environment safe product for power generation industry.
Electrical Cleaning Solvent
Features and Benefits
Odorless, non-emulsifying degreasing agent and non-conductive electro cleaner
Special degreasing agent for the removal of oil and grease from machines and motor parts, transmissions, ball bearings, gear wheels, metal parts, electrical components, etc.
Contains no chlorinated hydrocarbons or other harmful chemicals.
Does not emulsify in water - the polluted oil can be separated by means of an oil / water separator.
High flash point.
Clear, odourless, fluid neutral degreasing agent based on among other things, high boiling aliphatic hydrocarbon.
Stanrose® Electrosolv evaporates without residue. Stanrose® Electrosolv can be used on most metals, synthetic material, rubber and hardened metals, electrical components.
Specific gravity (20°C) : 0.758
Flashpoint : 62°C
pH : 7
Stanrose® Electrosolv can be applied with a brush or by spraying the parts to be cleaned. This product can also be used by filling an immersion bath to clean extremely dirty parts. The high flash point and the fact that it is practically odorless makes Stanrose® Electrosolv a pleasant and problem free product.
Method of Application
Stanrose® Electrosolv is used undiluted and unheated in immersion baths. Put the parts to be cleaned in the bath and soak for several hours. Thereafter, take the parts out of the bath and spray off with a forceful water-jet.
Attention: parts that need to be rust free and dry (such as electrical components) should not be sprayed clean with water but with clean Stanrose® Electrosolv and afterwards should be blow-dried completely because of fire risk if residues are left behind.
For the cleaning of dirty parts and surfaces use Stanrose® Electrosolv undiluted. Moisten the parts to be cleaned thoroughly with the product. Depending on the measure of dirt, soak the product for 5 to 60 minutes, brush in between. After this, rinse thoroughly with water.
Attention: parts that need to be rust free and dry (such as electrical components) should not be sprayed clean with water, but with Stanrose® Electrosolv and afterwards should be blow dried completely to avoid fire risk.
Storage and Handling
Cold cleaners should only be used in combination with oil/water separators. To guarantee an optimal oil/water separation, cold cleaners should never be used with greater amounts of emulsifying cleaners (e.g. of High Pressure Cleaners) if the waste is passing oil/water separators.
Avoid contact with eyes and skin. In case of contact rinse with plenty of water. Wear suitable protective clothing, gloves and eye/face protection.
Keep away from heat, sparks and open flame. Ensure that the working area is well ventilated.
Store at moderate temperatures in dry, well-ventilated area.
25 Ltr. / 210 Ltr.
bottom of page