top of page

Stanrose® Biostan Oil Cleaner

"Stanrose® Biostan Oil Cleaner" is a very strong cleaner, which can be used to soften up / remove baked on drying oils and used after animal and vegetable oils, fish oils, tall oils, tug oils etc .It is low toxic product with an exceptional solvency power on soil & oily matter. It is free from hydrocarbon solvents, Biodegradable minimizes the extreme hazards to personnel in handling materials.

Common Name

CTC Volc Cleaner

Product Code

STAN-CLC069

Features and Benefits

Removes grease, oil, carbon deposits, soil and grime.
Keeps loosened deposits in suspension preventing re-deposition.
Low toxic. , Non-flammable.
Free from hydrocarbon solvents.
Effective and economical in use , Water-based cleaner.

Technical Properties

Appearance Slightly Yellow Viscous
Ordour Characterisric
Density 1.00 at 20°C
Flash Point None
pH 7 at 20°C
pH Neat None on Cement, Ceramic Tiles, Vinyl or Metal Surfaces

Recommended Uses

It is a very strong cleaner, which can be used to soften up / remove baked on drying oils and used after animal and vegetable oils, fish oils, tall oils, tug oils etc

Method of Application

First of all flush the system with cold water to prevent evaporation rates and polymerization then the most economical method of using "Stanrose® Biostan Oil Cleaner" is by direct injection followed by re-circulation washing, using tank cleaning machines.
Spraying Method :
Using "Stanrose® Biostan Oil Cleaner" as delivered in drums, spray onto areas where residue remains following rough washing leave for 10-45 minutes (but do not allow to dry), then butterworth at maximum pressure and warm water 60oC for at least 3 hours, checking that there is no foam remaining in the final stages. Inspects tanks(s) and if desired result has been achieved fresh water rinse and dry.
**Make sure to take all safety precautions are followed when handling / spraying "Stanrose® Biostan Oil Cleaner"**
Injection Method : Not applicable.
Re- Circulation Method :
Fill tank with fresh water and heat up to warm 50o

C . If a drop line is available on the tank line system, then start to circulate the water and add the required amount of Caustic flakes and "Stanrose® Biostan Oil Cleaner" to make a 2.5% solution. A stronger solution can be made, but be advised that too much Caustic and too high temperature will result in white powder all over the tank. Under normal circumstances, between 2.5% and 4.5% will be sufficient strength. If there is no drop line, then lower butterworth hoses into the tank from the pump stack header without machines attached and circulate through these hoses while you fill the solution material.
**Use a strainer at the pump stack when circulating any solution.**
Tank Lining– Stainless / Epoxy / Phenolic.

Dosage :
Necessary concentration in water only 0,2 to 0,4 %

Storage and Handling

Avoid contact with eyes and skin. In case of contact rinse with plenty of water. Wear suitable protective clothing, gloves and eye/face protection.
Keep away from heat, sparks and open flame. Ensure that the working area is well ventilated.
Store at moderate temperatures in dry, well-ventilated area.

Packing Available

25 Ltr. / 210 Ltr.

bottom of page