Terrace / Roof Waterproofing

Stanrose Waterproofing

  • In Stanrose, a building or structure is waterproofed with the use of membranes and coatings to protect contents, and structural integrity.

  • In building construction, waterproofing is a fundamental aspect of creating a building envelope, which is a controlled environment. The roof covering materials, siding, foundations, and all of the various penetrations through these surfaces must be water-resistant and sometimes waterproof. Roofing materials are generally designed to be water-resistant and shed water from a sloping roof, but in some conditions, such as ice damming and on flat roofs, the roofing must be waterproof.

Our products have been tested and approved by trusted authorities such as CFTRI, CSIR, VJTI.

Our waterproofing system waterproofing is generally divided into two areas:


This is waterproofing used where the water table is lower than the structure and there is good free-draining fill. The membrane deals with shedding of water and the ingress of water vapor only, with no hydrostatic pressure. Generally, this incorporates a damp-proof membrane (DPM) to the walls with a polythene DPM under slab. With higher grade DPM, some protection from short-term Hydrostatic pressure can be gained by transitioning the higher quality wall DPM to the slab polythene under footing, rather than at the footing face.


This is waterproofing used where the below-ground structure will be sitting in the water table continuously or periodically. This causes hydrostatic pressure on both the membrane and structure, and requires full encapsulation of the basement structure in a tanking membrane, under slab and walls.



Staroxy Proof 2K is a two-component high performance water-based amine adduct cured epoxy coating specifically designed for protection of the internal masonry surfaces such as cement or concrete floor, cement or concrete wall, as well as glaze tile with appropriate primer. It is recommended for internal/external uses and immersion services. Ideal for factories, canteen, electronics, industries, pharmaceutical, hospital, offices and institution.

Click Here to Download TDS


Starothane Proof 2K is a waterborne, two component, polyurethane based topcoat which cures to a clear matt finish. Designed for use as a wear resistant top coat on elastic polyurethane-based coating systems. Incorporated where UV resistance needed & various weather conditions. Features are: -

  • Uniform clear, matt finish
  • NMP, APEO, VOC, glycol and solvent free
  • Very low emission (Certificates on demand)
  • Abrasion resistant
  • Improves scratch and wear resistance
  • UV resistant
  • Good adhesion to non-porous substrates
  • Low viscosity
  • Easy to clean and maintain