Stanrose® Deflame Electrosolv

Stanrose® Deflame Electrosolv is a fast evaporating cleaner that leaves no residue. The product is suited for cleaning electrical and electronic devices. The product is used as an electrical contact cleaner to remove grease, dirt, oil, flux and other surface contaminants from sensitive electrical/electronics devices. Stanrose® Deflame Electrosolv can also be used to clean motorized instruments, control panels, electrically driven equipment, motors and other electronic devices requiring non-flammable, low residue degreasing agents.

Common Name

Non Flammable Electric Cleaner

Product Code

STAN-CLC083

Features and Benefits

Stanrose® Deflame Electrosolv can also be used to clean motorized instruments, control panels, electrically driven equipment, motors and other electronic devices requiring non-flammable, low residue degreasing agents.

Technical Properties

Technology Solvent cleaner
Chemical Type Halogenated Solvent
Appearance Clear water-whiteLMS
Viscosity Very low
Application Cleaning of electrical / electronics devices
This product is not recommended for use in pure oxygen and/or oxygen rich systems and should not be selected with a sealant for chlorine or other strong oxidizing materials.

Recommended Uses

The product is used as an electrical contact cleaner to remove grease, dirt, oil, flux and other surface contaminants from sensitive electrical/electronics devices.

Method of Application

1. Hold can 15 to 20 cm () from surface to be cleaned.
2. Spray surfaces liberally. Extension tube can be used to pinpoint application.
3. Allow Stanrose® Deflame Electrosolv to fully evaporate from parts prior to bonding to avoid solvent entrapment within the bond joint.

Storage and Handling

The product is classified as flammable and must be stored in an appropriate manner in compliance with relevant regulations. Do not store near oxidizing agents or combustible materials. Store product in the unopened container in a dry location. Storage information may also be indicated on the product container labelling.
Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties.
Material removed from containers may be contaminated during use. Do not return product to the original container.
Stanrose cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.

Packing Available

25 Ltr. / 210 Ltr.